How to Play the Tin Whistle

Author Info

Last Updated: October 11, 2023 Approved

The tin whistle, also known as the penny whistle, Irish whistle, or just plain old whistle, is an instrument with a plastic or wooden fipple, or mouthpiece, and a metal body tube. They are fairly easy to play and the fingerings are similar to that of the saxophone, clarinet, and flute. Tin whistles are a great way to introduce someone to playing a musical instrument and lots of fun!

Steps

Download Article

1
Purchase a tin whistle at a local music store or online. Whistles are available in all the major keys. The most common, a D whistle, can play in the keys of D and G major.^{[1]
X
Research source} The second most common, a C whistle, can play in the keys of C and F major. The lowest note of a penny whistle, with all the fingers covered, is called the tonic - on a D whistle the tonic is D.
- The tone of the tin whistle is largely determined by its manufacturing. Clarke style rolled metal whistles tend to have a smooth soft sound, while Generation style cylindrical instruments tend to have louder or shrill whistle sounds. Inexpensive rolled metal whistles, such as those from Cooperman Fife and Drum (which also produces high-end instruments) may be very airy in sound, and may be difficult to play in the upper register (second octave). Often placing a piece of tape over one edge of the fipple slot (just below the mouthpiece) to narrow the fipple will improve the instrument's tone and playability significantly.
- Low whistles, or concert whistles, are longer and wider and produce tones an octave (or in rare cases two octaves) lower. Whistles in this category are likely to be made of metal or plastic tubing, with a tuning-slide head. The term soprano whistle is sometimes used for the higher-pitched whistles when it is necessary to distinguish them from low whistles.
It should face downwards and away from you at a 45 degree angle. Place your dominant hand at the bottom and your other hand at the top of the tube. Pinkies are not used except to support the whistle while playing certain notes, or when playing the largest (and lowest) tin whistles. Thumbs hold up the whistle from below. Cover the six keyholes with your fingertips. Place the tip of the fipple between your lips, but not between your teeth.^{[2]
X
Research source}

Advertisement
The standard range of the whistle is two octaves. For a D whistle, this includes notes from the second D above middle C to the fourth D above middle C. (It is possible to make sounds above this range, by blowing with sufficient force, but, in most musical contexts, the result will be loud and out of tune.) As you go up a note on a whistle you generally lift one finger.^{[3]
X
Research source} Read the tablature for a D whistle below. White holes indicate that it is uncovered, black indicate covered, and plus signs below the fingerings indicate the higher octave.
Hold the whistle with all the finger holes covered. (You don't need to press hard, just make sure each hole is completely covered.) Blow a steady stream of air, with your mouth shaped as if you were saying "too". This will produce the tonic (a D on the D whistle). Blowing too softly will make the note airy or nonexistent. Blowing too hard will produce the upper octave or a squeak. Blowing just right will create a steady, low tonic pitch. Progressively remove a finger at a time, starting by uncovering the hole at the end and working your way up to your mouth until you're playing the note with no holes covered (C#). You might need to use the pinky of your dominant hand to help support the whistle when none of the holes are covered.
Cover all the holes again and blow harder than before to get a higher pitch. If you're having trouble hitting the note, slightly uncover the top hole (the one closest to your mouth) and try again. Doing this might help with all the notes in the higher octave. Like before, uncover the holes, one at a time until you get to the highest note (C#). As the notes get higher, you'll have to blow harder to reach it. If you overblow, however, the whistle will squeak.
6
Play music! If you don't know already, learn how to read sheet music.
- If you have music transposed for a concert pitch instrument (violin, flute, piano) you can play this if it is in the right key. A player will usually play a whistle only in its tonic key and possibly in the key beginning on the fourth (e.g. G on a D whistle), but nearly any key is possible, becoming progressively more difficult to keep in tune as the player moves away from the whistle's tonic, according to the circle of fifths. Thus a D whistle is fairly apt for playing both G and A, and a C instrument can be used fairly easily for F and G.
  - To play a C natural on a D whistle or a B flat on a C whistle you can either half cover the top hole of the whistle^{[4]
    X
    Research source} or cover the two holes below the top hole. (The latter is more practical for faster playing.)
7
Practice! Not only should you be looking for clean, steady notes and smooth transitions between them, but you can also practice ornamentation:^{[5]
X
Research source}
- Cuts - Just before you play a note, play a higher note for an instant. Snap one of your fingers off a hole momentarily to hit the next higher note. It should be so short that the listener can't determine the pitch.
- Strikes - This is like a cut, except you go one note lower instead of higher.
- Sliding up a note - Slide your finger slowly off a hole so that you ease into the next note. It should only take about half a second.
- Vibrato can be achieved by varying the air speed slightly. Faster air means a higher tone, and slower air means a lower one, so by pulsing the air using your diaphragm, one can achieve vibrato. Don't blow too hard, or the instrument will play the next partial. Vibrato can also be achieved by opening and closing the second open hole counting down from the mouthpiece. For example, on the note A, play a normal A and wiggle your finger over the hole at the first finger of your dominant hand.

Community Q&A

Search

Add New Question

Question

When blowing into the whistle, do I say "doo, doo" or "ooo, ooo" or "too, too"?

Community Answer

Play it just like a recorder. If you want short, sharp, detached notes, play "too too". If you want softer ones, go "oo, oo".

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 5 Helpful 22
Question

How do I know which notes relate to which holes?

Community Answer

In most beginner music pieces, there are diagrams showing you which holes to use.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 6 Helpful 20
Question

What causes the tin whistle to make a screaming sound? Is it because I'm not holding the holes down tight enough? Or is it something in the way I'm holding it?

Community Answer

You are probably blowing too hard. Also, press the holes harder to prevent air escaping. You should press hard enough that you have little hole marks on your fingers.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 6 Helpful 12

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Tips

If spit collects in the fipple of the whistle (which is normal after playing), you will hear a weird, tinny sound, instead of the normal full tone. To remove the spit; cover the opening in the fipple with a finger and blow as if you are playing. (Covering the fipple opening silences the whistle, so you don't have to if you don't want to.) Make sure to blow away from other people and things--towards the floor is best. You don't want to spray someone with spit!

Thanks
Helpful 48 Not Helpful 17
Leading tones are the seventh just before the tonic. On most tin whistles the leading tone to the lowest tonic can be played by using the little finger of the lower hand to partially cover the very end opening of the whistle, while keeping all other holes covered as usual for the tonic.

Thanks
Helpful 37 Not Helpful 20
Tin whistles are fun to play around with. You can try playing notes with someone else's hand like in the picture. Also, see if you can play two notes on two whistles at the same time by yourself. To do this you would stick two whistles into your mouth (or three), cover as many holes as possible, and play. You might even be able to play a chord if someone lends you their hand!

Thanks
Helpful 2 Not Helpful 2

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

If you are sharing the whistle with another person, clean the fipple with some disinfectant before giving it to them.

Thanks
Helpful 24 Not Helpful 15
Use some form of swab to clean your whistle after playing or it could become unsanitary. A piccolo swab, which should be available at your local music store, will be the right size. Alternately you could use a bit of cloth (an old t-shirt will do) and a piccolo tuning rod. Flute and piccolo tuning rods look like large needles so they can be "threaded" and used as a swab.

Thanks
Helpful 0 Not Helpful 0